Famous How To Change Jeep Wrangler Key Fob Battery References. Line up the front cover of the key fob over the rear cover and snap them together. Make sure that the negative side of the battery is facing downwards.
Open the driver’s door and while it is open, press the lock button on the door panel. Find the notch to open the fob. Double check that the two halves are flush all around.
They Do Die Over Time.
Remove the battery and exchange it for a new cr2032 battery. Remove the jeep key fob battery from its housing. Turn the key to the on position but do not start the engine.
The Next Step Is To Take The Circuit Board And Place It Into The Keypad.
Reprogram your jeep key fob (optional). Press the lock button on the key fob and hold it for 5 seconds. Be sure to insert it with the negative side facing downward.
Press Down Lightly On The Top Of The Screwdriver To Force The Two Key Fob Segments Apart At The Seam.
Apply pressure on the screwdriver as you pry it open. Line up the front cover of the key fob over the rear cover and snap them together. Test the new key fob battery by standing near your jeep wrangler and pushing the lock or unlock buttons.
Locate The Release Button On The Back Of The Key Fob.
It will cost approximately $4.99, depending on your jeep model and year. Replace the circuit board in the keypad. In this video, dave shows us how to replace battery in jeep wrangler key fob.
Double Check That The Two Halves Are Flush All Around.
Put the circuit board into the keypad, then put the. Read below to find out. Remove the old battery from its housing.