+26 How To Use A Drain Snake Kitchen Sink References. If you didn’t remove the trap, consider running cold water while you snake. Gather a bucket, rubber gloves, and a drain auger or snake.
The plate is attached using 2 screws. The drain inlet will be located on the wall behind the sink or on the floor below it. Once these are removed, insert the drain snake into the pipe leading into the wall and auger.
The First Step Is To Turn Off The Shut Valve Located Under The Sink.
Once the path is clear insert the drain snake into the drain opening and start turning the handle clockwise. Insert the snake cable into the drain. The auger begins its journey down the drain.
To Use A Snake You Need To Disconnect The Trap Assemply Pipes From The Drain Inlet.
Here are a few accessible, fast best practices to bear in mind to prevent clogging of your kitchen sink drains: Use adjustable pliers or a pipe wrench to remove the fittings. But, do you know how to unclog a sink drain.
With The Trap Disconnected, Look Into The Pipe And See If You Can See Any Obstructions.
So now you are ready to place the sink plunger over the drain itself. Make sure you remove any hair or similar clogs from your drain that are within easy reach. How to use a drain snake get access to the drain by removing the overflow assembly or stopper.
Pull Out A Foot Of Cable And Insert The End Of The Snake Into The Drain Until You Feel.
Carefully insert the drain snake’s head inside the overflow drain and start. If a kitchen sink is still clogged after snaking, the issue is likely deeper in the drain. Thes pipes drain out into a sewer or septic system.
Remove The Overflow Drain Plate.
Do not flush food away from the kitchen sink. You know that drain cleaners and solvents should only be used as last resort when it comes to unclogging drains. To fix this issue, shut off the water supply, unscrew the pipe under the sink, and push the drain snake in.